- Insert the key into the driver’s side door lock.
- Turn the key once, but not all the way to unlock the door. Leave the key in this position for 40-60 seconds. …
- Do this again, but turn the key in the opposite direction.
- Remove the key from the door, get into your Ford, and start the engine. The system should be reset.
How do you fix the anti-theft on a Ford Fusion?
What is the Ford Fusion anti-theft system reset procedure? Resetting your anti-theft system is as easy as turning your key in the ignition eight times in 10 seconds, leaving the last turn in the “run” position. Then, press and hold a button on the remote for 30 seconds to lock the vehicle.
How do you fix a car anti-theft system?
Method 1: Check the cylinder and key
Step 1: Check the key fob battery. The anti-theft system on a car might activate if you have a dead key fob battery and the system hasn’t been disabled. Check to be sure that the battery on your key fob is installed correctly. Step 2: Check the door lock cylinder.
How long does it take for the anti-theft system to reset?
Leave the key there for 15 minutes; it doesn’t always take that long, but it can. After that time, check to see if the anti-theft light has gone out, if one was lit up. Turn the key backward two places to the Lock position, then wait three more minutes. When that has elapsed, try to start the car.
What triggers the anti-theft system in car?
The Anti-theft alarm system works with the help of sensors installed in and around the vehicle. An impact or the movements inside the car activates the sensors. This, in turn, triggers the Anti-theft alarm system and sounds the alarm. The alarm goes off and alerts the owner/people.
Can anti-theft stop car from starting?
It is possible that the system can trigger the car alarm or prevent the engine from running without any apparent reason. You have to shut it off if it is not working properly. The car won’t return to normal operation unless you fix the issue of anti theft device car wont start.
Why would the anti-theft light come on?
If the security or anti-theft light is flashing when you attempt to start your car, and the engine does not crank or does not start, you have an anti-theft problem. The system may not be recognizing your key or keyless entry signal, or there may be a fault in the anti-theft module, keyless entry system or wiring.
Why does my Ford car alarm keep going off?
Some of the reasons your car alarm keeps going off include faulty sensors, low battery, wiring problems, and a broken key fob. It could also be from unevenly closed doors. While an alarm or ECU reset can fix most issues, others may require professional services.
Does anti-theft light drain battery?
The anti-theft light won’t drain your battery. But, if you leave the car alarm to go off for long, it can drain the battery.
Why is my Ford Fusion not starting?
The most common reasons a Ford Fusion won’t start are a dead battery, an alternator problem, or failed starter.
How does the Ford PATS system work?
Ford PATS Passive Antitheft System uses a key with a transponder in the head of the key. Each transponder is coded with a unique identifying code made from a possible 18 billion combinations. It’s a passive system because it doesn’t require any input from the driver.
Can a locksmith fix anti-theft system?
The cost to fix this problem would probably be the cost of a new key. You will simply need a new key if the system is not recognizing the old key and the anti theft system doesn’t shut off. This is mostly because of a burned chip inside of the key. A new programmed key by an experienced locksmith will do the trick.
Can you disable anti-theft system?
To turn off the anti-theft system, use your remote to press the unlock button key. It is advised to use the key to unlock the door and turn on the ignition switch. If that does not work, try to lock the door on the driver’s side using the key while you are out of the car.
How do I disable anti-theft on my car?
Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two.
Is there a fuse for anti-theft system?
You can find the alarm fuse in the panel. Look in the owner’s manual to find the exact location of the fuse used by the security system. While the fuse is out, the car is not going to start. However, you can reinsert it and hopefully reset the alarm.
What does the car with the lock symbol mean?
The lock and car symbol and warning light you are seeing is saying that the anti-theft system has been activated. Your owner’s manual should give more information on how to reset this light. This may also be what is causing the parasitic draw on the battery.
What is anti-theft system in Ford?
The Ford F-150 is equipped with a passive anti-theft system (PATS) which is an alarm and engine immobilization system. It’s designed to help stop your truck from being stolen by preventing the engine from starting unless a correctly coded integrated keyhead transmitter is used.
How do I reset my immobilizer?
Hold the panic button for five seconds to reset the immobilizer. Then press the lock button twice and wait ten meters from the car for ten minutes.
Will disconnecting battery reset car alarm?
If you’re still having trouble with the alarm, disconnecting your car’s battery may be the next best option. This will both silence the alarm and reset it—or at least it should. You may also want to refer to your owner’s manual for the location of the alarm’s transmitter system.
Why is my car flashing theft?
The Anti-theft Light in the dash of your car should flash periodically to show that the system is engaged and active. You have to lock the doors of the car (without it running) for the alarm to engage.
The security alarming light blinks continuously even when the vehicle is OFF. The flashing red light is a security light to keep things safe.